The 802.11ax protocol, also known as Wi-Fi 6, provides the fastest bandwidth among the options listed. It can achieve up to 10 Gbps of data transfer rate, using technologies such as OFDMA, MU-MIMO, and 1024- QAM. The 802.11ac protocol, or Wi-Fi 5, is the second fastest, with a maximum of 3.46 Gbps, followed by the 802.11n protocol, or Wi-Fi 4, with a maximum of 600 Mbps. The 802.11a protocol is the slowest, with a maximum of 54 Mbps
https://www.lifewire.com/wireless-standards-802-11a-802-11b-g-n-and-802-11ac-816553

A custom hosts file is a file that maps hostnames to IP addresses, allowing the user to access websites or servers by their names instead of their numerical addresses. For example, a user can add a line like 192.168.1.100 myserver.local to their hosts file and then access the server by typing myserver.local in their browser. However, this method only works if the IP address of the server does not change. If the server is configured with a dynamic IP address, which means it can be assigned a different IP address by the network router or DHCP server, then the hosts file entry will become invalid and the user will not be able to connect to the server by its hostname. Therefore, the technician should ensure that the server is configured with a static IP address, which means it has a fixed and permanent IP address that does not change. This way, the hosts file entry will always point to the correct IP address of the server and the user will be able to ping the server hostname from their computer.
References:
How to Add a Local DNS Lookup to Hosts File - Help Desk Geek1
Set Custom Domain Name for localhost Website in IIS - TutorialsTeacher.com2 The Official CompTIA A+ Core 1 Student Guide (Exam 220-1101) eBook, page 4-9

One of the possible causes of the error message "No Source Found" is that the projector is not receiving any signal from the connected device, such as a laptop1. This could be due to an incorrect input source selected on the projector or an improper display setting on the laptop. Therefore, the first actions that the technician should take are to verify the projector settings and make sure the correct input is selected, and to check the laptop display settings and set them to extend/duplicate23.

The correct answer is A. Toner probe.
A toner probe is an electronic test instrument that can help trace wires and locate the port where a printer is connected on a patch panel. A toner probe consists of two parts: a tone generator and a tone detector. The tone generator sends a signal through the cable, and the tone detector picks up the signal at the other end. By using a toner probe, a technician can identify which port on the patch panel corresponds to the printer cable.
A loopback plug is a device that can test the functionality of a network port by sending and receiving signals from the same port. A loopback plug is not useful for locating ports on a patch panel.
A cable tester is a device that can verify the integrity and continuity of a cable by checking for open, short, or miswired connections. A cable tester can also measure the length and resistance of a cable. A cable tester is not useful for locating ports on a patch panel.
A Wi-Fi analyzer is a software or hardware tool that can monitor and analyze wireless networks by scanning for available channels, signal strength, security settings, and other parameters. A Wi-Fi analyzer is not useful for locating ports on a patch panel.
Reference: comptia A+ Core 1 - Hardware And Network Troubleshooting - ExamGuides.com

If lines appear down copied pages but printed pages sent directly to copier render as intended, it could be due to scratched scanner glass which can cause lines or streaks on copied pages.
If there are lines appearing on copied pages, but not on printed pages sent directly to the copier, the issue is most likely caused by a scratch on the scanner glass. References: https://www.pacificoffice.com/how-to-fix- lines-on-copier/